DXS-3326GSR Stackable Gigabit Layer 3 Switch
config syslog host all
local4 − Specifies that local use 4 messages will be sent to the
remote host. This corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages will be sent to the
remote host. This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages will be sent to the
remote host. This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages will be sent to the
remote host. This corresponds to number 23 from the list above.
udp_port <int> − Specifies the UDP port number that the syslog
protocol will use to send messages to the remote host.
state [enable | disable] − Allows the sending of syslog messages
to the remote host, specified above, to be enabled and disabled.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure all syslog hosts:
DXS-3326GSR:4#config syslog host all severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DXS-3326GSR:4#
delete syslog host
Purpose Used to remove a syslog host, that has been previously
configured, from the Switch.
Syntax
delete syslog host [<index 1-4> | all]
Description
The delete syslog host command is used to remove a syslog
host that has been previously configured from the Switch.
Parameters
<index 1-4> − Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
all − Specifies that all syslog hosts will be deleted.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete a previously configured syslog host:
76
To Next Page
Loading...
