4
NOTE: Under no circumstances should unit be completely sealed in
recessed installation. Allow access for service. Picture surface
is centered in case. Case extends 4" beyond surface on either end.
Do not attach anything to screen slat rod or bottom fabric pocket.
1. Make sure screen is level. Use a carpenter’s level and plumb
level.
2. Remove tape and rubber bands from slat pocket.
CAUTION! Do not cut wrapping paper or tape with knife or
any sharp tool. Remove by hand.
ATTENTION! Ne coupez pas le papier d'emballage ou le
ruban adhésif avec un couteau ou un outil tranchant. Retirez
à la main.
3. Install electrical hook up that applies to your unit. Make sure to
review your Electrical Installation Checklists and wiring diagrams
(included) for either 120 volt switch, 220/240 volt switch, or low
voltage control.
4. Test installation by running screen up and down a few times.
Be prepared to stop screen. Standard Duty Cycle:
1 MIN. ON / 3 MIN. OFF.
NOTE: Must be installed in accordance with the requirements of the
Local Building Codes, the Canadian Electrical Code (CEC), CAN/CSA
C22.1 and the National Electric Code (NEC), NFPA 70.
NOTE: DO NOT clean end caps with any cleaning solution. Use only
damp cloth to clean dust from screen case.
Installation Continued
To Next Page
Loading...
