We thank you for using our product. Please refer to this manual or contact our office if
you find any problems during using our product.
This product is an indicator that emplifies the micro voltage signals from each sensor
and display in digital. It is mainly used to measure physical quantities of the items using
strain guage such as loadcell, pressure sensor, displacement sensor and torque sensor.
This product has the following special features.
Calibration by actual load (standard weight) and calibration by rated output of sensor.
You can choose peak hold and sample hold as per your need.
You can do set-up the maxium and lower limit value by the keys on the front panel
and print with contact point signal of the rear panel.
All the set-up values will be memorized on the flash memory so the inputted data can
be saved and no need to do the re-setting even in case of the interruption of the
electric power or power disconnection.
This function is for automatic reset in case the system is stopped due to the external
factors such as noise.
• OP-01 : Parallel BCD output
• OP-02 : RS232C Interface (basic installation)
• OP-03 : RS485 Interface
• OP-10 : Power DC24V 0.3A
Additional optional RS232C, RS485, or BCD outputs are available, and our standard
protocol and Modbus RTU protocol can be selected from Function settings.
AC 90 ~ 240V 50/60Hz 8VA (Option : DC24V 0.3A)
Model DN-70,80 Power: DC24V 0.2A
To Next Page
Loading...
Need help?
General
