Daedong DK65 - Temperature Gauge; Tachometer;Hour Meter; Hazard Lamp Switch

DISCRIPTION OF OPERATING SYSTEM 4-9
628O411A
When the hazard lamp switch is pulled to
the ON position, the hazard lamps blink.
HAZARD LAMP SWITCH
(1) Hazard Lamp Switch
(A) Hazard Lights OFF (B) Hazard Lights ON
CAUTION
Prolonged use of the hazard
lamps without the engine running
will drain the battery. Use only in
case of emergency.
628O412A 628O413A
TACHOMETER/HOUR METER
Always check the engine coolant level
before starting the tractor.
The temperature gauge indicates the en-
gine coolant temperature. Always allow
the tractor to reach its normal operating
temperature before doing work.
Immediate action is required if the tem-
perature exceeds the normal range. Do
not operate the tractor if the temperature
gauge reaches the red section of the
range.
TEMPERATURE GAUGE
(1) Hour Meter
(2) Engine Revolution Meter
(1) Temperature Gauge
The hour meter shows the number of
hours the tractor has been operated at
rated engine rpm. The last digit (white
background) indicates 1/10 of an hour.
The tachometer indicates engine speed
in revolutions per minute (RPM).