Daedong DK65 - REMOTE HYDRAULIC CONTROL LEVER

5-22 DK65/75/80/90
WARNING
When leaving the driver’s seat to
attach or detach implements:
Shift the transmission into
neutral.
Set the parking brake.
Slow the engine to idle speed.
Push the draft control lever for-
ward to the floating range.
Keep bystanders clear of the trac-
tor and the implement.
1. Adjust the position (leveling) of the
implement by turning the lift linkage lo-
cated on the right side.
2. After the adjustment, secure with the
lock nut.
3. Positioning is dependent upon the type
of implement.
LEVELING ADJUSTMENT (MANUAL)
628O539A
(1) Lift Linkage
1. Level or tilt the implement from the
operator’s station. Setting depends on
the type of implement.
2. Activate the rocker switch to make the
leveling adjustment.
LEVELING ADJUSTMENT (LIFT CYLIN-
DER EQUIPPED) (DK75,80,90)
628O540A
(A) Up (B) Down
The lift can be controlled from the ground
while attaching or detaching implements.
REMOTE HYDRAULIC CONTROL LEVER
628O541A
(1) Remote Hydraulic Control Lever