DAELIM VS125 - Inspection and Starting Procedures

14
HEADLIGHT·POSITION LAMP
Switch position
H
P
Funcation
Headlight and
tali/stop light turned on
Position lamp and
taillight turned on.
Light turned off
●Do not operate main switch key while driving.
If the main switch key is placed on “O f f”or
“L o c k”position, all electrical system will not
f u n c t i o n .
●Do not operate the main switch key during travel
as it might cause unexpected accidents, If it is
necessary to remove the main switch key, stop
the vehicle first prior to removing.
●Prior to dismounting from the vehicle , make sure
to lock the steering wheel and remove key.
<TURNING ON HEADLIGHT>
Put main switch key in “ON” position
and turn on headlight switch.
●When you travel after sunset, put
headlight in low-beam. This lets
approaching vehicles know of your
position and is helpful for safe driving.
<HEADLIGHT HIGH OR LOW BEAM OPERATION>
High beam or low beam can be operated
by the use of high/low beam switch.
HI
...
Headlight placed on high beam
LO
...
Headlight placed on low beam
H EA D L I G H T󰼿 SW I TC H
H EA D L I G H T󰼿 H I G H /L O W 󰼿
BEA M 󰼿S W I T C H
SWITCH OPERATION
영문-메뉴얼작업󰼿󰼿2005.12.29󰼿5:3󰼿PM󰼿󰼿페이지14