DAELIM VS125 - Cleaning and Storage Guide

38
SPARK PLUG
PLU G 󰼿 G AP
●If the plug of different maker or
different heat value is used, it
causes unsatisfactory engine
starting, inadequate engine revol-
ution and output deterioration.
●The spark plug must be securely
t i g h t e n e d . An improperly tightened
plug can become very hot and
possibly damage the engine.
●To install a spark plug, turn it in as
far as possible with your fingers,
then t ighten it wit h a wrench.
Do not overtighten or cross thread
the spark plug or the aluminum
threads of the cylinder head will be
d a m a g e d .Do not allow contaminants
to enter the engine through the spark
plug hole when the plug is removed.
If electrode is stained or plug gap is not
right, satisfactory spark is not produced.
Clean and make adjustment.
●Remove spark plug cap.
●Clean around the plug.
●Using a plug wrench, remove plug.
●Clean plug with plug cleaner.
●Check electrode for wear and corrosion.
if the center of electrode became round,
replace the electrode.
●Measure the spark plug gap using a
feeler gauge.
PLUG GAP: 0.8-0.9mm
●Tighten with hands until the plug
washer touches cylinder head.
STANDARD PLUG: CR8EH-9
●If new plug is installed, turn 1/2 and
tighten using a plug wrench.
If plug is reused, turn 1/3~1/4 and
t i g h t e n
<DEALING WITH POOR STARTING>
When the starter doesn’t work during
driving in winter times or in a repeated
short distance, use the suitable spark plug
for this driving condition.
Poor starting may happen when nonstop
driving in low speed, even though we
produce standard plug.
In case starter isn’t working well in driving
repeatedly in a short distance or in an area
with many traffic signals, use the CR7EH-9
plug instead of standard plug CR8EH-9
영문-메뉴얼작업󰼿󰼿2005.12.29󰼿5:14󰼿PM󰼿󰼿페이지38