DAELIM VS125 - Changing Engine Oil

If engine oil is polluted, it seriously affects
the engine life span. Maintain appropriate
level of oil, use correct type of oil and
observe oil exchange period.
●Stand vehicle on the main stand on level
ground and run engine idle (warm up)
for approximately 2-3 minutes.
●Stop engine and place a container under
the engine.
Remove oil level gauge and drain bolt.
●Clean oil filter screen.
●Check the condition of oil filter screen
seal rubber and, o-ring.
●Close oil filter screen, spring, and oil
drain bolt, and replenish oil up to the
upper level of the oil level gauge.
OIL CAPACITY: 1.0ℓ
<RECOMMENDED OIL>
●Do use genuine oil to protect and extend
vehicle life
●As far as any defect caused by conta-
minated gasolin or oil, no warranty shall
be assured.
29
●Be sure to keep oil away from
children and pets. Dispose of
used oil properly.
●If you change engine oil imme-
diately after engine is stopped,
be careful of burns because the
engine, muffler and engine oil
are still hot.
●Exercise caution not to allow
dust or other foreign matter to
flow in when refilling engine
oil. If oil overflows, wipe off oil
clean.
●If oil level is lower or higher
than prescribed level, engine is
adversely affected.
●Do not mix oil with those of
different manufacturers or
grade, or do not use low-quality
oil as it may cause deterioration
of oil, leading to accidents.
●Clean the oil filter screen with
fresh cleaning oil every
4,000km.
● Be careful not to lose the oil
filter screen sp ring when
assembling the oil drain bolts.
CHANGING ENGINE OIL
GRADE(SE , 󰼿SF , 󰼿SH)
O I L󰼿F I LTER󰼿SC R EEN O I L󰼿 D RA I N󰼿B O LT
O I L󰼿F I LTE R 󰼿 S C REE N 󰼿 S PR I N G
영문-메뉴얼작업󰼿󰼿2005.12.29󰼿5:11󰼿PM󰼿󰼿페이지29