DAELIM VS125 - Safe Driving Practices; Preparation, Precautions, and Driving Methods

40
CABLE RUBBER PART CLEANING
A rubber part is assembled on the cable to
protect the inner cable.
Make sure that this part is placed firmly
around the correct part of the cable. When
washing the car, do not directly spray
water on to the rubber part is dirty, use a
dry cloth to clean this area.
Clean your motorcycle regularly to protect
the surface finishes and inspect for
damage, wear, and oil, coolant or brake
fluid leakage.
1. After cleaning , rinse the motorcycle
thoroughly with plenty of clean water.
Strong detergent residue can corrode
alloy parts.
2.Dry the motorcycle , start the engine, and let
it run for several minutes.
3.Test the brakes befor riding the motorcycle .
Several applications may be necessary
to restore normal braking performance.
4.Lubricate the drive chain immediately after
washing and drying the motorcycle .
●Infiltration of the foreign materials
or water caused by damage of
lever(disengagement, tearing, etc.)
may cause freezing in winter season
resulting in faulty operation, sudden
accelation and braki ng force
decrease. If any damage is found,
replace wit h the new on
immediately.
●Parking efficiency may be temporarily
impaired immediately after washing the
vehicle.Anticipate longer stopping distance
to avoid a possible accident.
INSPECTION󰼿PART INSPECTION󰼿PART RUBBER
●Make sure to stop the engine prior to car
w a s h i n g .
●High pressure water (or air) can damage
certain parts of the motorcycle.
●Be careful not to allow water to enter the
muffler during the washing. Water inside
the muffler may cause an improper
engine starting or rust occurrence.
●Do not let water get inside the braking
system during the washing, as water
inside the brake system may weaken the
braking power. Upon completion of
washing, select a safe place where there
is no traffic obstruction, and start the
vehicle.
Lightly apply the brake while driving at a
slow speed and check the braking power.
If the braking power has been weakened,
apply brake lightly while driving at a
slow speed to dry up the brake system.
영문-메뉴얼작업󰼿󰼿2005.12.29󰼿5:15󰼿PM󰼿󰼿페이지40