20
PARKINGOPERATION HOW TO USE BRAKE
●Start carefully as slow as possible.
●If you hear abnormal noise during
travel, contact authorized maintenance
shop immediately for inspection and
necessary action.
●Maintain legal speed limits.
●Select a safe place free of traffic and
park vehicle.
●Muffler is hot. Park vehicle in places
where there is no danger for people to
contact with vehicle.
●If you apply brakes only on front
wheel or rear wheel, vehicle may
slide off sideway and fall.
●If you apply brakes abruptly during
travel in rain or on wet road, tires
slide off and may cause accidents.
Reduce speed and apply brake
c a u t i o u s l y .
●Avoid repeated brake operation as it
may cause brake temperature to rise,
leading to braking effect deterioration.
●A brupt downshift may cause the
shake of rear parts.
●Make sure side stand is in original
position prior to starting vehicle.
●If side stand moves unsatisfactorily,
check lubrication state on side stand
joint.
●Shift gear adequately according to
vehicle speed.
●To save fuel and maintain optimum
vehicle life, do not accelerate or
decelerate speed abruptly.
●Apply brakes on front wheel and rear
wheel simultaneously.
●Avoid unnecessary abrupt braking.
<ENGINE BRAKE>
If you turn throttle grip in reverse, engine
brake functions and, if you need stronger
braking, shift gear down from 4th to 3rd
and so forth. When you travel on a long
descent or on a sharp descent , use
intermittent braking technique and engine
brake simultaneously.
●Put gear in neutral and put main switch
to “OFF” position to stop engine.
●Put fuel cock to “OFF” position.
●Put vehicle on main stand and park on
level ground in places free of traffic. If
you park vehicle on an uneven ground,
vehicle may fall.
<
PARKING WHEN SIDE STAND IS USED
>
Stop vehicle on level ground and park with
the steering wheel turned to left.
If the vehicle is parked in the following way,
vehicle may fall to side.
●If the vehicle is parked with the steering
wheel turned to right, or if parked on a
slope, sandy places, uneven ground or soft
ground, vehicle may fall.
●If is necessary to park in an unstable
ground under unavoidable situation, take
sufficient safety measures to prevent
vehicle from falling or moving.
<BREAK-IN OPERATION>
Maintain engine revolution at a level less
than 6,000rpm for first 1,000km to break
in vehicle. If vehicle is broken in as above,
the life span of equipment is prolonged.
영문-메뉴얼작업2005.12.295:5PM페이지20