Daewoo Kalos - Scanning All the Tracks on a Cassette (SCAN)

4–52 CLIMATE CONTROL AND AUDIO SYSTEM
Skipping blank spaces (blankskip)
You can automatically skip blank
spaces on the tape that are longer than
ten seconds. To do so, the blankskip fea-
ture must be activated.
Scanning all the tracks on a cassette (SCAN)
You can briefly play (scan) all the
tracks on a cassette.
½ Press the SCAN button (15).
"CAS SCAN" appears in the display.
All the tracks on the cassette are briefly
played in ascending order.
To stop scanning,
½ press the SCAN button (15) again.
The currently scanned track will then
continue to be played normally.
NOTE
• You can set the scantime. For fur-
ther details, read the section en-
titled "Setting the scantime" in the
"Radio mode" chapter.
• In order to be able to use the
S-CPS, RPT and SCAN functions,
there must be a pause of at least
three seconds between each track
on the cassette.
Pausing playback
You can pause the cassette whilst it is
playing,
½ to do so, press the 2 0 button (12).
Playback is paused and "PAUSE" ap-
pears in the display.
To cancel pause mode,
½ press the 2 0 button (12) again.
Switching radiomonitor ON/OFF
NOTE
You can only switch the radio-moni-
tor on/off whilst a cassette is playing.
½ Press the MENU button (11).
½ Keep pressing the B or Y button (8)
until "RM ON" or "RM OFF“ ap-
pears in the display.
½ Press the << or >> button (8) to
switch the radiomonitor on/off.
When you have finished making your
changes,
½ press the MENU button (11).
Switching Blankskip ON/OFF
½ Press the MENU button (11).
½ Keep pressing the B or Y button (8)
until "BLK SKIP" appears in the dis-
play.
To switch blankskip on/off,
½ press the << or >> button (8).
When you have finished making your
changes,
½ press the MENU button (11) twice.
NOTE
You can only switch "blankskip" on/
off whilst a cassette is playing.