SERVICE AND VEHICLE CARE 6–41
LICENSE PLATE LAMP
Bulb replacement
1. Remove the two screws and the lamp
covers.
2. To remove the bulb holder from the
lamp housing, rotate the bulb holder
counterclockwise.
3. Pull the bulb out from the bulb
holder.
4. Replace the bulb. See “BULB SPECI-
FICATIONS” in the index.
5. Install the bulb holder into the lamp
housing by rotating the bulb holder
clockwise.
6. Replace the lamp covers.
Bulb replacement (Hatchback)
1. Open the tailgate.
2. Pull down the lamp housing while
holding the end of the two retaining
clips up.
S3W6562A S3W6563A
3. Pry off the lens cover using a flat
head screw driver.
4. Remove the bulb by pulling it
straight out of the bulb holder.
5. Install a new bulb. See “BULB
SPECIFICATIONS” in the index.
6. Reinstall the lamp housing.
To Next Page
Loading...
