6–36 SERVICE AND VEHICLE CARE
vv
vv
v WARNING
Halogen bulbs contain pressurized
gas. Take special care when han-
dling and disposing of halogen
bulbs.
• Wear eye protection when work-
ing with bulbs.
• Protect the bulb from abrasions
and scratches.
• When the bulb is illuminated and
not in a sealed installation, pro-
tect the bulb from contact with
liquids.
• Only illuminate the bulb when it
is installed in a lamp.
• Replace a cracked or damaged
headlamp.
• When replacing halogen bulbs,
DO NOT touch the glass part
with bare fingers.
• Keep the bulbs away from chil-
dren.
• Dispose of used bulbs with care.
Otherwise the bulbs can explode.
vv
vv
v CAUTION
• Clean your halogen bulbs with al-
cohol or mineral spirits and a lint-
free cloth. Be sure not to touch
them with your bare hands.
Fingerprints may drastically shorten
the effective life of halogen bulbs.
LAMPS
HEADLAMPS
Bulb replacement
1. Open the hood.
2. Disconnect the wiring harness con-
nector from the rear of the bulb.
3. Remove the headlamp cap.
4. Release the spring that retains the
bulb.
5. Remove the bulb.
6. Install the proper replacement
headlamp bulb. See “BULB SPECI-
FICATIONS” in the index.
7. Reinstall the bulb retaining spring.
8. Replace the headlamp cap.
9. Connect the wiring harness con-
nector.
S3W6502A
To Next Page
Loading...
