1–14 SEATS AND OCCUPANT PROTECTION SYSTEMS
vv
vv
v WARNING
Removed or improperly adjusted
head restraints can result in serious
head and neck injuries in case of a
collision.
HEAD RESTRAINTS
Head restraints are designed to reduce
the risk of neck injuries in case of a col-
lision.
For maximum protection, slide the head
restraint up or down so the top of the
restraint is level with the top of your
ears.
To adjust the front and rear* head re-
straints, raise the head restraint or push
it down while pressing the release
button.
6. Adjust and tighten the child restraint
according to the instructions supplied
with the child restraint.
7. Push and pull on the child restraint
after installation to be sure the child
restraint is secure.
vv
vv
v CAUTION
• Keep the zippers covering the
Lower Child Restraint Anchors
closed when the anchors are not
in use.
Leaving the zipper covers open
could allow foreign objects to accu-
mulate around the Lower Child Re-
straint Anchors, interfering with the
proper latching of the child restraint
to the anchors.
4. Make sure there are no foreign ob-
jects around the Lower Child Re-
straint Anchors, including safety belt
buckles or safety belts. Foreign ob-
jects can interfere with the proper
latching of the child restraint to the
anchors.
5. Place the child restraint on the seat
over the two Lower Child Restraint
Anchors and attach it to the anchors
following the instructions supplied
with the child restraint.
S4W1123A
To Next Page
Loading...
