29
Figure 5-10
Click to modify VTO parameter info. Click to delete added VTO.
Note:
For VTO in use, you cannot modify it or delete it.
5.2.3.2 Indoor Station Manager
Warning:
After you have added a single VTH, we do not recommend you to batch add VTH,
since this operation will overwrite original VTH. Please add VTH one by one after
batch operation.
You can add VTH via either method below:
Add one VTH
Step 1. Select System Config>Device Manager>Outdoor Station Manager. System
shows Outdoor Station Manager interface.
Step 2. Check VTO you want to add VTH, such as 8001.
Step 3. Select “8001-indoor station manager” tab.
Step 4. Click Add. System shows Figure 5-11.
Figure 5-11
Step 5. Configure parameters, see chart below.
To Next Page
Loading...
