34
reboot. After a while, WEB interface directly goes to new IP address.
You also can modify VTO IP in Project Setup>IP Setup local interface.
Figure 5-18
Enter number as IP address.
Subnet Mask
According to actual condition, subnet mask prefix is number, enter
1～255，part of subnet prefix is a special network link, which in
general include a layer structure.
Default Gateway
According to actual condition, it must be in the same segment
Default Click “Default”, to restore all parameters in this page to default.
Refresh Click “Refresh”, to refresh this page.
5.2.4.2 FTP Config
Back up record and picture to set FTP server for storage and view.
Note:
FTP is enabled by default.
Step 1. Select System Config>Network Config>FTP Config. See Figure 5-19.
To Next Page
Loading...
