User’s Manual
168
Parameter Description
Show Message
Select the Show Message checkbox to enable a pop-up message in your local
host PC.
Send Email
Select the Send Email checkbox
to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main Menu >
NETWORK > Email.
Buzzer Select the checkbox to activate a buzzer noise at the Device.
Log Select the checkbox to enable the Device to record a local alarm log.
Post Record
Continue to record for some time after the alarm is ended. The value ranges
from 10 seconds to 300 seconds.
Alarm Tone
Select to enable audio broadcast/alarm tones in response to a network alarm
event.
Click Apply to complete the settings.
5.10.6 Configuring Disarming
You can disarm all alarm linkage actions as needed.
Select Main Menu > ALARM > Disarming.
Click to enable disarming.
Disarming
(Optional) Select Off to disable event notifications.
To Next Page
Loading...
Need help?
General