Dahua DHI-ASI7213Y-V3-T1P - System

24
 Select Wiegand Output when the access controller works as a reader that can be connected to
the controller. See Table 3-8.
Table 3-8 Wiegand output
Parameter Description
Wiegand Output Type
The Wiegand Output Type determines the card number or the digit of
the number that can be recognized by the access controller.
Wiegand26, three bytes, six digits.
Wiegand34, four bytes, eight digits.
Wiegand66, eight bytes, sixteen digits.
Pulse Width
You can set pulse width and pulse interval.
Pulse Interval
Output Data Type
You can select the types of output data.
User ID: If User ID is selected, and then user ID will be output.
Card No.: If Card No. is selected, and then card number will be
output.
System
3.10.1 Time
You can do date format setting, date setting, time setting, DST setting, NTP check, and time zone
settings.
 When you select Network Time Protocol (NTP), you need to enable the NTP Check function
first. Server IP Address: enter the IP address of the time server, time of the access controller will
be synchronized with the time server.
 Port: Enter the port number of the time server.
 Interval (min): NPT check interval. Tap the save icon to save.