Dahua DHI-ASI7213Y-V3-T1P - Image Mode; Fill Light Mode Setting; Fill Light Brightness Setting; Volume Adjustment

27
Name Description
Mask Mode
No detect: Mask is not detected during face recognition.
Mask reminder: Mask is
detected during face recognition. If the
person is detected without wearing a mask, the system will prompt
mask reminder and passage is allowed.
Mask intercept
: Mask is detected during face recognition. If the
person is detected without wearing a mask, the system will prompt
mask reminder and passage is not allowed.
3.10.3 Image Mode
There are three options:
 Indoor: Select Indoor when the access controller is installed indoors;
 Outdoor: Select Outdoor when the access controller is installed outdoors;
 Other: Select Other when the access controller is installed at places with backlights like
corridors and hallways.
3.10.4 Fill Light Mode Setting
You can select fill light modes according to your needs. There are three modes:
 Auto: When the photo sensor detects that the ambient environment is not dark, the fill light is
normally off; otherwise, the fill light will be on.
 NO: The fill light is normally on.
 NC: The fill light is normally closed.
3.10.5 Fill Light Brightness Setting
You can select fill light brightness according to your needs.
3.10.6 Volume Adjustment
Tap or to adjust the volume.
3.10.7 IR Light Brightness Adjustment
The larger the value is, the clearer the images will be; otherwise the unclearer the images will be.
3.10.8 Restore to Factory Settings
 Data will be lost if you restore the access controller to the factory settings.