49
The red rectangles are motion detection area. The default motion detection range is all the
rectangles.
To draw a motion detection area, you need to click Remove All first.
The motion detection area you draw will be a non-motion detection area if you draw in the
default motion detection area.
Motion detection area
Set sensitivity and threshold.
Sensitivity represents the ability of each grid to sense motion. The larger the value is, the
higher the sensitivity is.
Threshold is the condition of motion detection. When grid number reaches the threshold,
motion detection will be triggered. The smaller the value is, the more likely the motion
detection will be triggered.
When grid number is smaller than the threshold, green line will appear; when grid number
is more than the threshold, red line will appear. See Figure 4-14.
Click OK to finish the setting.
4.6.5 Volume Setting
You can adjust volume of the access controller speaker.
Volume setting
To Next Page
Loading...
