38
4 Web Operations
The access controller can be configured and operated on the web. Through the web you can set
network parameters, video parameters, and access controller parameters; and you can also maintain
and update the system.
Initialization
You need to set a password and an email address before logging in to the web for the first time.
Open IE web browser, and enter the IP address (the default address is 192.168.1.108) of the
access controller in the address bar, and then press Enter.
Use browser newer than IE 8, otherwise you might not log in to the web.
Make sure that the computer used to log in to the web is in the same LAN with the
device.
Initialization
Enter the new password, confirm password, enter an email address, and then click Next.
The password must consist of 8 to 32 non-blank characters and contain at least two types
of characters among upper case, lower case, number, and special character (excluding ' " ; :
&). Set a password of high security level according to the password strength prompt.
For security, keep the password properly after initialization and change the password
regularly.
When you need to reset the administrator password by scanning the QR code, you need an
email address to receive the security code.
Click Next.
To Next Page
Loading...
