53
Parameter Description
monitored temperature is 0.5 °C lower than the actual temperature,
the correction value is set to 0.5 °C; if the monitored temperature is
0.5 °C higher than the actual temperature, the correction value is set
to -0.5 °C.
Only the access controller with a temperature monitoring unit supports
this parameter.
Mask Mode
No detect: Mask is not detected during face recognition.
Mask reminder: Mask is detected during face recognition. If the
person is detected without wearing a mask, the system will prompt
mask reminder and passage is allowed.
Mask intercept: Mask is detected during face recognition. If the
person is detected without wearing a mask, the system will prompt
mask reminder and passage is not allowed.
Click OK to finish the setting.
Network Setting
4.8.1 TCP/IP
You need to configure IP address and DNS server to make sure that the access controller can
communicate with other devices.
Make sure that the access controller is connected to the network correctly.
Select Network Setting > TCP/IP.
TCP/IP
Configure parameters.
To Next Page
Loading...
