42
Screen management Figure 4-27
Select a block from the drop-down list of Block. Step 1
In the block, select one or more screens, and then click ON or OFF to turn on or turn off the Step 2
screen.
4.3.4.6.2 Power Switch
According to the requirement, connect the decoder with serial port cable of LED screen, to control
the power of LED screen.
If manufacturer protocol is DH-LED-N or LED-CLT, video signal can be displayed on LED. When Power
Switch tab is displayed in Screen Management interface, the system can control LED power to turn
on/off.
Select Power Switch. The Power Switch interface is displayed.
Power switch Figure 4-28
To Next Page
Loading...