Dahua DHI-NVD0905DH-4I-4K - Page 96

89
4.5.5.3.2 Global Setup
You can configure to enable main/sub stream auto switch, window prompt info and "do not decode
when being covered".
Select Setup > Display Management > Display Setup > Global Setup. Step 1
The Global Setup interface is displayed.
The interface of 1-channel 4K high definition (h.265) series is slightly different. The actual
interface shall prevail.
Global setup Figure 4-99
Select the check boxes. Step 2
Table 4-22 Global setup parameters description
Parameter Description
Main/Sub Stream Auto
Switch
If main stream is displayed on the window, when the resolution is lower
than D1, main stream will automatically switch to sub stream.
IVS Rule
After the camera enables IVS rule function,
rule line turns red and
flickers if a moving object enters the alarm zone of blue rule line.
Tracking Box
After the camera enables tracking box function, the system selects and
tracks moving objects with a green box on the output interface.
Window Prompt Info Prompt information will be displayed on the window.
Do not decode when
being covered
The covered window will pause decoding.
Platform NetCard Pull
Stream
Enable platform netcard pull stream function.
1-channel 4K high definition (H.265) series
does not support this
function.