User’s Manual
249
In the Access Type list, select USB Gateway, Camera Gateway, or All.
When Access Type is Camera Gateway, you can select Channel to filter the status of present
wireless detector.
Click .
The Setting interface is displayed.
Setting
Configure the settings for alarm linkage.
Table 5-39 Alarm linkage settings
Name Enter the customized alarm name.
Schedule
Click
to display setting interface.
Define a period during which the motion detection is active. For details, see
"Setting Motion Detection Period" section in "5.10.4.1 Configuring Motion
Detection Settings."
PTZ Linkage
Click
to display the PTZ interface.
Enable PTZ linkage actions, such as selecting the preset that you want to be
called when an alarm event occurs.
Alarm-out Port
Click
to display setting interface.
Local Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
Extension Alarm: Enable alarm activation through the connected alarm
box.
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300 seconds,
and the default value is 10 seconds.
To Next Page
Loading...
