User’s Manual
250
Post Record
Set a length of time for the Device to delay turning off recording after the
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and
the default value is 10 seconds.
Anti-Dither Configure the time period from end of event detection to the stop of alarm.
Record Channel
Select the channel(s) that you want to record. The selected channel(s) starts
recording after an alarm event occurs.
The recording for alarm and auto recording must be enabled. For details, see
"5.1.4.9 Configuring Recorded Video Storage Schedule" and "5.9.1 Enabling
Record Control."
Snapshot
Select the
check box to take a snapshot of the selected channel.
To use this function, select
Main Menu > CAMERA > Encode > Snapshot
,
in the
list, select
.
Tour Select the
check box to enable a tour of the selected channels.
Alarm Tone
Select to enable audio broadcast/voice prompts in response to a local alarm
event.
More Setting
Show Message: Select the
check box to enable a pop-
up message in your local host PC.
Buzzer: Select the check box to activate a buzzer noise at the Device.
Video Matrix: Select the check box to enable the function. When an
alarm event occurs, the video output port outpu
configured in "
Main Menu > DISPLAY > Tour
."
Not all models support this function.
Send Email:
Enable the system to send an email notification when an
alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > Email
.
Log: Select the check box to enable the Device to record a local alarm
log.
Extra screen: Select the check box to enable the function. When an
alarm event occurs, the extra screen outputs the settings configured in
Main Menu > DISPLAY > Tour > Sub Screen.
Not all models support this function.
To use this function, extra screen shall be enabled.
Click OK to save the settings.
On the Wireless Detector interface, click Apply to complete the settings.
To Next Page
Loading...
Need help?
General