User’s Manual
257
More Setting
Show Message: Select the
check box to enable a
pop-up message in your local host PC.
Buzzer: Select the check box to activate a buzzer noise at the
Device.
Video Matrix: Select the check box to enable the function. When an
alarm event occurs, the video output port outputs the settings
configured in "
Main Menu > DISPLAY > Tour
."
Not all models support this function.
Send Email:
Enable the system to send an email notification when
an alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > Email
.
Log: Select the check box to enable the Device to record a local
alarm log.
Extra screen: Select the check box to enable the function. When an
alarm event occurs, the
extra screen outputs the settings
configured in
Main Menu > DISPLAY > Tour > Sub Screen.
Not all models support this function.
To use this function, extra screen shall be enabled.
Click Save to save the settings.
5.12.2.4.2 Configuring Alarm Settings for Humidity Data
You can configure the alarm event by setting the humidity data.
On the main interface, select IoT > Management > Temperature/Humidity.
To Next Page
Loading...
Need help?
General