User’s Manual
66
The Record interface is displayed.
Record
Configure the record settings parameters.
Channel In the
list, select a channel to record the video.
Pre-record
In the
list, enter the amount of time that you want to start the
recording in advance.
Redundancy
If there are several HDDs installed to the Device, you can set one of the
HDDs as the redundant HDD to save the recorded files into different HDDs.
In case one of the HDDs is damaged, you can find the backup in the other
HDD.
Select
Main Menu > STORAGE > Disk Manager
, and then set a HDD
as redundant HDD.
Select
Main Menu > STORAGE > Schedule > Record
, and then select
the
check box.
If the selected channel is not recording, the redundancy function takes
effect next time you record no matter you select the check box or not.
If the selected channel is recording, the current recorded files will be
packed, and then start recording according to the new schedule.
Not all models support this function.
The redundant HDD only back up the recorded videos but not
snapshots.
Event type
Select the check box of the event type which includes
,
(motion detect, video loss, tempering, diagnosis),
(IoT alarms, local
alarms, alarms from alarm box, IPC external alarms, IPC Offline alarms),
,
(IVS events, face detection), and
.
Period
Define a period during which the configured recording setting is active.
The system only activates the alarm in the defined period.
Copy Click
to copy the settings to other channels.
Define the video recording period by drawing or editing. By default, it is active all the time.
To Next Page
Loading...
