Dahua IPC-HFW2100P Series User Manual

27
Here you can also add, modify or remove UPnP item. See Figure 4-13.
In the Windows OS, From Start->Control Panel->Add or remove programs. Click the “Add/Remove
Windows Components” and then select the “Network Services” from the Windows Components Wizard.
Click the Details button and then check the “Internet Gateway Device Discovery and Control client” and
“UPnP User Interface”. Please click OK to begin installation.
Enable UPnP from the Web. If your UPnP is enabled in the Windows OS, the IPC can auto detect it via
the “My Network Places”
Figure 4-13
4.2.8 SNMP
The SNMP interface is shown as in Figure 4-14.
The SNMP allows the communication between the network management work station software and the
proxy of the managed device. Please install the software such as MG MibBrowser 8.0c software or
establish the SNMP service before you use this function. You need to reboot the device to activate the
new setup.

Dahua IPC-HFW2100P Series Specifications

General

Brand	Dahua
Model	IPC-HFW2100P Series
Category	IP Camera
Language	English