36
Parameter Function
Anti-dither
System only memorizes one event during the anti-dither period.
The value ranges from 0s to 100s.
Relay out Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
alarm occurs.
Alarm Delay
System can delay the alarm output for specified time after alarm
ended. The value ranges from 10s to 300s.
Record
channel
System auto activates motion detection channel to record once
alarm occurs (working with motion detection function). Please
note you need to go to Storage-> Schedule to set current channel
as general record.
Record Delay System can delay the record for specified time after alarm ended.
The value ranges from 10s to 300s.
Send Email If you enabled this function, System can send out email to alert
you when alarm occurs and ends.
PTZ
z
Here you can set PTZ movement when alarm occurs. Such as
go to preset x when there is an alarm.
z
The event type includes: preset, tour and pattern.
Snapshot You need to check the box here so that system can backup
motion detection snapshot file.
4.3.1.2 Video Masking
The video masking interface is shown as in Figure 4-23.
Figure 4-23
To Next Page
Loading...
Need help?
General