Dahua IPC-HFW2100P Series User Manual

35
Figure 4-22
Please refer to the following sheet for detailed information.
Parameter Function
Enable You need to check the box to enable motion detection function.
Sensitivity
There are six levels. The sixth level has the highest sensitivity.
Region
z
There are six levels. The sixth level has the highest sensitivity.
z
Region: If you select motion detection type, you can click this
button to set motion detection zone. The interface is shown as
in Figure 4-22. There are PAL 22X18/NTSC 22X15 zones. Right
click mouse you can go to full-screen display mode. Do
remember clicking OK button to save your motion detection
zone setup.
Working
Period
z
Motion detection function becomes activated in the specified
periods. See Figure 4-21.
z
There are six periods in one day. Please draw a circle to enable
corresponding period.
z
Select date. If you do not select, current setup applies to today
only. You can select all week column to apply to the whole
week.
z
Click OK button, system goes back to motion detection
interface, please click save button to exit.

Dahua IPC-HFW2100P Series Specifications

General

Brand	Dahua
Model	IPC-HFW2100P Series
Category	IP Camera
Language	English