EasyManuals Logo
Home>Dahua>Network Hardware>NVR100 series

Dahua NVR100 series User Manual

Dahua NVR100 series
501 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #222 background imageLoading...
Page #222 background image
212
Figure 4-48
Step 8 Set camera IP address
Check DHCP, there is no need to input IP address, subnet mask, and default gateway. Device
automatically allocates the IP address to the camera.
Check Static, and then input IP address, subnet mask, default gateway and incremental value.
Note
If it is to change several devices IP addresses at the same time, please input incremental
value. Device can add the fourth address of the IP address one by one to automatically
allocate the IP addresses.
If there is IP conflict when changing static IP address, device pops up IP conflict dialogue
box. If batch change IP address, device automatically skips the conflicted IP and begin the
allocation according to the incremental value
Step 9 Click Next button.
Device begins initializing camera. See Figure 4-49.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dahua NVR100 series and is the answer not in the manual?

Dahua NVR100 series Specifications

General IconGeneral
BrandDahua
ModelNVR100 series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals