EasyManuals Logo

Dahua NVR100 series User Manual

Dahua NVR100 series
501 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #329 background imageLoading...
Page #329 background image
319
Figure 4-170
Figure 4-171
4.8.1.9 IP Filter
IP filter interface is shown as in Figure 4-172. You can add IP in the following list. The list supports max 64
IP addresses. System supports valid address of IPv4 and IPv6. Please note system needs to check the
validity of all IPv6 addresses and implement optimization.
After you enabled trusted sites function, only the IP listed below can access current NVR.
If you enable blocked sites function, the following listed IP addresses cannot access current NVR.
Enable: Highlight the box here, you can check the trusted site function and blocked sites function.
You cannot see these two modes if the Enable button is grey.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dahua NVR100 series and is the answer not in the manual?

Dahua NVR100 series Specifications

General IconGeneral
BrandDahua
ModelNVR100 series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals