Dahua NVR1104HS-W Series User Manual

User's Manual
279
Figure 4-181
Step 2 Select a channel and alarm type, enable the thermal alarm function.
Step 3 Select fire mode and then enable this function (If the alarm type is
Fire Alarm
).
System supports preset mode and zone excluded mode.
●
Preset
: Select a preset and then enable the function. System generates an alarm
once it detect there is a fire.
●
Global
: System filters the specified high temperature zone. System generates an
alarm once the rest zone has fire.
Step 4 Set parameters. See Table 448.
Table 4-59
Parameter
Description
Alarm-out Port
The alarm device (such as lights, sirens, etc.) is connected to the
alarm output port. When an alarm occurs, the NVR device transmits
the alarm information to the alarm device.
Post-Alarm
When the alarm ends, the alarm extended for a period of time. The
time range is from 0 seconds to 300 seconds.
Show Message
Check box to enable a pop-up message in your local host PC.
Report Alarm
Select the check box. When an alarm occurs, the NVR device
uploads an alarm signal to the network (including the alarm center).
● This function is for some series products only.
● You need to set the alarm center first. For details, see "4.12.13
Alarm Center".
Send Email
Select the check box. When an alarm occurs, the NVR device sends
an email to the set mailbox to notify the user.
You need to set the email first. For details, see "4.12.10 Email".

Dahua NVR1104HS-W Series Specifications

General

Brand	Dahua
Model	NVR1104HS-W Series
Category	Network Hardware
Language	English