User's Manual
310
Select the available sites that you want to connect to. When the NVR
is connected to a site and then select another site to connect, the
current site will be disconnected before the new site is connected.
Step 3 Click
Apply.
● After the connection is successful, a Wi-Fi connection signal flag appears in the
upper-right corner of the live view interface.
● The Wi-Fi module models currently supported are D-LINK, dongle and
EW-7811UTC wireless cards.
4.12.4 Wi-Fi AP
Prerequisites
This function requires the built-in Wi-Fi module in the device, and actual product shall prevail.
You can configure Wi-Fi parameters for the NVR to ensure that a wireless IPC can connect to
the NVR through Wi-Fi AP.
4.12.4.1 General Settings
You can configure SSID, encryption type, password and channel of the device.
● This function is supported on select wireless models.
● When the wireless IPC and NVR are matched, the pairing will be completed in 120
seconds after they are powered-on.
Step 1 Select
Main Menu
>
NETWORK
>
Wi-Fi AP
>
General
.
The
General
interface is displayed. See Figure 4-210.
To Next Page
Loading...
Need help?
General
