Dahua PFS4218-16GT-190 - 4.2 Monitor

Advanced Settings 58
Input the VLAN ID in Source VLAN(s) Configuration. Step 3
Configure the Source and the Destination in Port Configuration. Step 4
Click Save.
Step 5
4.1.13 Serial Config
Set the conversion between the asynchronous serial port and the Ethernet.
Select Advanced > Configuration > Serial Config. The Serial Config interface is displayed.
See Figure 4-78.
Serial Config Figure 4-78
Monitor 4.2
4.2.1 System
4.2.1.1 Information
You can view the system information of the device, including system, hardware, time, and
software.
Select Advanced > Monitor > System > Information. The System Information interface is
displayed. See Figure 4-79.
Information Figure 4-79
4.2.1.2 CPU Load
You can view the CPU load within the unit interval. The lines of three different colors stand for
the CPU load rate in different time intervals.