Dahua VTO2000A Series

Figure 5- 1
Note:
Parameter with * is madantory, while others are optional.
Step 4. In LAN Config interface, check group call, click OK.
Step 5. After config is complete, enter logout interface, reboot VTO.
See Figure 5- 2.
Figure 5- 2
Configure Main VTH
Step 1. In VTH screen, press System Config, and press Project settings, input password
(default is 002236), and enter Project settings interface.
Step 2. Press Local Info, input room no., local IP, subnet mask, see Figure 5- 3 and
Figure 5- 4.
Note:
Room no. must match VTH short no. in Figure 5- 2.