Dahua VTO2000A Series User Manual

Figure 5- 3
Step 3. Press network, fill in VTO IP address.
Figure 5- 4
Set Extension
Step 1. In VTH screen, press System Config, and press project settings, input password
(default is 002236), and enter project settings interface.
Step 2. Press local info. Press master and it changes to extension.
Step 3. Set room no., fill in local IP, subnet mask and gateway.
Step 4. In master IP fill in main VTH IP. After setup is complete, extension will auto synv

Dahua VTO2000A Series Specifications

General

Brand	Dahua
Model	VTO2000A Series
Category	Intercom System
Language	English