3.3 Editing Using an External Personal Computer
3-19
5
Check whether the contents of the list screen displayed are as expected for all the
pages.
>> If there is a format or other error in the parameters described in the interface panel
files, the corresponding part will be replaced with a "0." For all switches on all the
pages, check whether such parts exist.
CAUTION
At this point, the files have not yet been stored or loaded into the internal memory.
If import is failed, please correct the character code referring the list of 3.3.2 Editing
usin
g a personal computer.
6
If everything is OK, press f12 <Complete>.
The settings are saved in the constants files (S**SIGL.CON I/O constants file and
C**CTRL.CON controller general constants file).
(To stop editing at any time, press the [RESET/R] key.)
INFO.
When a file impose is executed, if the conversion source file has any erroneous description,
keywords on lines with erroneous display contents of import results will be all displayed.
Referring to this display, make corrections to the conversion source file.
Furthermore, if the file import does not normally end, the display will return to setting prior to
the execution of the import.
The following section shows causes, due to which the import does not normally end.
Parameter values are inappropriate or fall outside of the setting range.
The specification of input and output signal numbers has been already allocated.
Input and output having the same signal number are found within the interface panel
setting.
Parameters following the parameter P__DATA are short on numbers.
There are no descriptions on the parameter P__DATA corresponding to P_.
There are no descriptions on the parameter P_ corresponding to P__DATA.
There are no descriptions on the parameter P_ corresponding to P__NAME.
There are no descriptions on the parameter P__DATA corresponding to
P__NAME.
To Next Page
Loading...
General