6
To switch the humidifying operation ON/OFF
Press “
”.
Each time it is pressed, the humidifying operation ON/OFF will switch.•
When the humidifying operation ON/OFF is switched humidity indicator lamp indicate temporarily as shown below.•
In case the humidifying operation is turned ON: the humidity indicator lamp will be changed and indicate the setting.•
In case the humidifying operation is turned OFF: the humidity indicator lamp will turn OFF for 2 seconds.•
7
To change the humidify setting
Press “
”.
Each time it is pressed, the humidity indicator lamp indicate temporarily as shown below.•
“STD”(Standard)“LOW”(Low) “HIGH”(High) “CONT”(Continuous)
8
To decide a time to stop operation
Press “
”.
Each time it is pressed, the timer setting switches as shown below. The remaining time will be lit in the OFF timer lamp.•
“4”(4 hours)“1”(1 hour) “8”(8 hours) (Cancel)
When the set time is reached, the operation will automatically stop.•
The set time can be changed if the button is pressed while the timer is operating.•
9
To change the brightness of the operation panel lamps and front indicator lamps
Press “
”.
Each time it is pressed, the display will switch as shown below.•
<Operating panel lamps>
<Front indicator lamps>
Page 11, 12.
Bright Dimmed Dimmed Bright Dimmed OFF
Only the front indicator lamps go completely off.•
10
To prevent incorrect operation
Press “
” for 2 seconds.
Stops the function of the button other than the “• ” on the main unit and buttons on the remote controller.
This makes it possible to prevent children from operating the unit incorrectly.•
To release the child proof lock settings, press “•
” again for 2 seconds.
To release the child proof lock settings when the remote controller is not in your hand, press “ •
” of the unit for 2 seconds.
NOTE
The unit will not operate for 3 seconds after the front panel is set or power plug is inserted even though “ ● ” button on the remote
controller is pressed.
Operation will stop for safety when the front panel is opened during operation. ●
When an incorrect operation is performed during operation. ●
If the main unit display is abnormally on or remote controller is disabled due to thunder or radio transmission during operation, pull the
power plug and then re-insert it after 3 seconds.
01_EN_3P234570-1.indd 2201_EN_3P234570-1.indd 22 10/28/2008 12:02:45 PM10/28/2008 12:02:45 PM
To Next Page
Loading...
Need help?
General
