Care & Cleaning
Front panel cleaning
Wipe
Wipe off dirt with a piece of cloth or tissue moistened with water.•
For stubborn dirt, wipe with a cloth moistened with a neutral liquid detergent.•
Do not use hard bristle brushes, etc. •
Tools of the sort may scratch the front panel.
Do not use petrol, benzene, thinner, scouring powder, kerosene, •
alcohol, etc.
Substances of the sort may lead to cracking, electric shock or ignition.
Do not wash the unit frame with water. •
Contact with water may lead to electric shock, fi re or damage.
Sensor air inlet cleaning
(Dust, odor, temperature and humidity sensors)
Vacuum cleaner
Using a vacuum cleaner nozzle attachment with a narrow opening, •
suck up dust adhering to the air inlets and sensor holes.
Vacuum cleaner
If dust has accumulated, suck it up with a vacuum •
cleaner.
NOTE
Be careful not to scratch the front of the front panel or damage the projections on the back of it when it is removed. ●
The projections on the backside operate as a safety switch that shuts power OFF when the panel is opened.
If damaged, the unit cannot be started.
Top hole
Be careful not to damage these projections.
Rear of front panel
Projection
In the rear of the hole at the top of the unit is a •
safety switch, therefore do not touch it.
Touching the switch may result in electric shock.
If the switches are accidentally damaged and the •
unit cannot be started as a result, contact the
service shop.
01_EN_3P234570-1.indd 2701_EN_3P234570-1.indd 27 10/28/2008 12:02:48 PM10/28/2008 12:02:48 PM
To Next Page
Loading...
Need help?
General
