HOW TO OPERATE
1
Press .
If humidifi cation was run the last time that the unit was used, humidifi cation starts automatically, therefore press • to turn
OFF the humidifi cation lamp.
2
Press to change the airfl ow rate.
Each time the button is pressed, the airfl ow rate changes as follows. •
Air flows at a super slow rate.
This mode is recommended when sleeping.
Airflow rate ((Quiet) (Low) (Standard) (High)) is
automatically adjusted according to the dirty state of
the air.
This is the high airflow rate mode that quickly removes
airborne dust.
The airflow rate is changed every 5 minutes to create
gentle air currents so as to catch the pollen before
settling on the floor.
Quiet mode Anti-pollen mode
Turbo modeAuto mode
(Automatic) (Quiet) (Low) (Standard) (High) (Turbo) (Pollen)
ATTENTION
The default settings are air purifying operation and “auto” airfl ow rate control. ●
If the power supply cord is unplugged or if the front panel was opened and the unit restarted, the next time that the unit is used, it runs at
the last used settings.
Air Purifying Operation
1
Humidification lamp
2
Plug the power supply cord
into an electrical socket.
NOTE
Do not insert or remove the power plug to turn the unit on/off. ●
Abusive handling may lead to electric shock or fi re because of overheating.
Socket
Power plug
01_EN_3P234570-1.indd 1901_EN_3P234570-1.indd 19 10/28/2008 12:02:44 PM10/28/2008 12:02:44 PM
To Next Page
Loading...
Need help?
General
