22
Daintree
™
Controls
|
WHS20/WHR1
User Manual
|
V1.0
Commission Assist Menu
The Commission Assist menu provides a variety of tools that can be used to make the configuration of the lighting
control system easier. Each of the menu options is described in detail below. The Commission Assist tools can
be accessed from the Main Menu by selecting “Info” (in the upper right corner) and then “Commission Assist”.
Device Identification
The following options help with identifying an individual WHS20 sensor after it has been installed.
Begin Identify Sequence – Flashes the LED luminaire connected to the device for 20 seconds so that you can
identify it.
Retrieve Device ID – Retrieves the device identifier of a device
Retrieve Device Licenses – Shows the modes and functions licensed for that device
Retrieve All Device Info – Shows the Manufacturer, Model Number, Device ID, iBeacon Info, Firmware Version
and Licenses for that device
To Next Page
Loading...
Need help?
General