Daitsu APD09-AL - Remote Controller; Handling the remote controller; Replacing batteries

29
ENGLISH
REMOTE CONTROLLER
Handling the remote controller
Location of the remote controller.
•Usetheremotecontrollerwithinadistanceof8meters
fromtheappliance,pointingittowardsthereceiver.
Receptionisconrmedbyabeep.
CAUTION
Theairconditionerwillnotoperateifcurtains,doorsorothermaterialsblockthesignalsfromthe•
remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose the remote controller to direct •
sunlight or nest.
Iftheinfraredsignalreceiverontheindoorunitisexposedtodirectsunlight,theairconditionermaynot•
functionproperly.Usecurtainstopreventthesunlightfromfallingonthereceiver.
Ifotherelectricalappliancesreacttotheremotecontroller,eithermovetheseappliancesorconsultyour•
local dealer.
Replacing batteries
Theremotecontrollerispowedbytwodrybatteries(R03/
LR03X2)housedintherearpartandprotectedbyacover.
(1) Removethecoverbypressingandslidingoff.
(2) Removetheoldbatteriesandinsertthenewbatteries,
placingthe(+)and(-)endscorrectly.
(3) Reattachthecoverbyslidingitbackintoposition.
NOTE:Whenthebatteriesareremoved,theremote
controllererasesallprogramming.Afterinsertingnew
batteries,theremotecontrollermustbereprogrammed.