Daitsu APD09-AL - FOLLOW ME operation; ION operation; SLEEP operation; Other features

46
ENGLISH
- When the malfunction (E1 or E2) occurs, the
Auto Start/Stop timed program will also be
cancelled.
FOLLOW ME operation (on some models)
This feature can be activated from the remote
controlONLY.Theremotecontrolservesas
a remote thermostat allowing for the precise
temperature control at its location.
To activate the Follow Me feature, point the remote
control towards the unit and press the Follow
Me button. The light on the unit control panel
will illuminate to indicate it received the signal.
It will continue to send this signal until the feature
is deactivated by pressing the Follow Me button
again. If the unit does not receive the Follow Me
signal during any 7 minutes interval, the unit will
beep to indicate the Follow Me mode has ended.
The display on the remote control indicates the
temperature at the remote only.
ION operation (on some models)
This feature can be activated from the remote
control too.
ToactivatetheIONoperation,theaniongenerator
is energized and will help to remove pollen and
impurities from the air.
SLEEP operation
Press this button, the set temperature will increase
(cooling) or decrease (heating) by 1ºC / 2ºF in 30
minutes. The set temperature will then increase
(cooling) or decrease (heating) by another 1ºC
/ 2º after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it
returns to the originally selected temperature. This
ends the Sleep mode and the unit will continue to
operate as originally programmed.
NOTE:ThisfeatureisunavailableunderFANor
DRY mode.
Other features
Auto-Restart (on some models)
Iftheunitbreaksoffunexpectedlyduetothepower
cut, it will restart with the previous function setting
automatically when the power resumes.
Wait 3 minutes before resuming operation
After the unit has stopped, it can not be restarted
operationintherst3minutes.Thisistoprotect
the unit. Operation will automatically start after 3
minutes.
Air ow direction adjustment
The louver can be adjusted automatically.
Adjusttheairowdirectionautomatically(Fig.4):•
- WhenthePowerisON,thelouveropensfully.
- PresstheSWINGbuttononthepanelorremote
controller to initiate the Auto swing feature.
- The louver will swing up and down automatically.
- Please do not adjust the louver manually.
Swings automatically
Fig. 4