II. Safety
Dakewe (Shenzhen) Medical Equipment Co., Ltd. 5
www.dakewemedical.com
incident prevention. The primary person responsible for safe operation is the institution that owns the
equipment, followed by the person assigned by the institution to operate, maintain or repair the equipment.
To ensure smooth operation of the equipment, be sure to observe the following instructions and warnings.
1. Warning - Symbols on the equipment
An indication of warning triangle symbol is displayed on the equipment. The correct operating
instructions as defined in this manual must be followed during operation or replacement. Failure to
comply with the instructions may result in incidents, injury to personnel, or damage to equipment
or accessories.
2. Warning - Transport and installation
The equipment may be shaken, tilted or lifted during transport, so shakable parts, including
input hopper, batch output hopper, must be secured or removed prior to each transport - otherwise
the equipment can be damaged.
Lifting up and carrying the equipment from the packaging box requires 2 people to work
together.
After unpacking, the equipment must be kept upright during carrying.
Strictly observe the instructions for unpacking to avoid damage to the equipment!
The equipment must be placed on a horizontal surface, and the location must have good
ventilation to ensure that the equipment has sufficient space for heat dissipation.
Do not place the equipment in an environment with flammable ignition source and explosive
hazard.
Do not expose the equipment to direct sunlight.
The equipment shall be connected to a grounded mains outlet and shall not be connected to an
extension board without a protective ground conductor.
If the equipment is connected to a mains supply with a voltage different from that indicated on
the label, serious damage may be caused.
3. Warning - Operation
The Dakewe slide printer should only be operated by trained laboratory personnel in
accordance with the intended use and instruction manual.
In case of emergency, turn off the main power and unplug the power switch.
During operation, do not block the hopper motor drive assembly with objects or bare hands, or
it can cause injury.
Load slides according to equipment markings or indications, and make sure that the slides are
loaded in the right direction.
Dispose of slides in accordance with laws, regulations and waste management policy
requirements of the institution.
Load input hopper and batch output hopper according to equipment markings and instructions,
and make sure that the hoppers are inserted properly.
Input hopper and batch output hopper must not be pulled when the equipment is resetting.
To Next Page
Loading...