Replacement Parts and Exchange and Repair Programs
25
9 Replacement Parts and Exchange and Repair
Programs
Daktronics Part Numbers
All parts in Daktronics displays are assigned a part number. Daktronics part numbers are
commonly found on drawings and are used when requesting replacement parts from
Daktronics Customer Service. Take note of the following part number formats.
• “0P-_ _ _ _-_ _ _ _” denotes an individual circuit board.
• “0A-_ _ _ _-_ _ _ _” denotes an assembly. An assembly can be a single circuit board or
a collection of components that function together, usually mounted on a single plate
or in a single enclosure.
• “0Z-_ _ _ _-_ _ _ _” denotes an assembly.
• “W-_ _ _ _” denotes a wire or cable. Cables may also carry the assembly numbering
format in certain circumstances. This is especially true of ribbon cables.
• “PR-_ _ _ _ _-_ _” denotes a specially ordered part.
Most circuit boards and components within this DDMS set
carry a label listing the part number of the unit. If a circuit
board or assembly is not in the replacement parts list, use
the label to order a replacement. A typical label is shown in
Figure 14. The part number is bolded.
Tools
• Stubby Phillips screwdriver
• Small Phillips screwdriver
• Small at-head screwdriver
• Small pliers
• Medium Phillips screwdriver
• Medium at-head screwdriver
• Nut driver (
3
/
8
")
• Allen wrench (
5
/
32
")
• Cable ties
• Multimeter
• Clamp-on ground meter
Figure 14: Typical Label
To Next Page
Loading...
