EN
Page | 33
14.3 Replacing the lamp
ELECTRIC SHOCK HAZARD!
Before replacing the lamp, switch off the appliance, remove the mains plug and
switch off or unscrew the fuse.
RISK OF BURNS!
Unscrew the lamp only after switching off the appliance and allowing the lamp to
cool down completely. The lamp is hot and can provoke minor burns.
Lamp data: max. 2 x 1.5 W (LED)
1. Disconnect the appliance from the mains power supply.
2. To replace the lamp, first remove the filter unit.
3. Remove defective lamps.
4. Do not touch the new lamp directly with your fingers; use a clean cloth for
this.
5. Carefully insert the new lamp into the lamp bracket.
6. Carefully fit the filter unit into the extractor hood again.
7. Connect the appliance to the power supply again.
To Next Page
Loading...