Spyder 3 CL User's Manual PRELIMINARY 83
DALSA 03-032-20008-03
Analog Offset: 70 70
Analog offset settings
set with the
sao
command. See section
7.5 Analog and Digital
Signal Processing Chain
for details.
Digital Offset: 0 0
Digital offset settings
set with the
sdo
command. See section
7.5 Analog and Digital
Signal Processing Chain
for details.
Background Subtract: 0 0
Background subtract
settings set with the
ssb command. See
section
7.5 Analog and
Digital Signal
Processing Chain for
details.
System Gain (DN): 4096 4096
Digital gain settings set
with the
ssg command.
See section
7.5 Analog
and Digital Signal
Processing Chain for
details.
Returning Camera Settings with Get Commands
You can also return individual camera settings by inserting a “get” in front of the
command that you want to query. If the command has a tap or pixel number parameter,
you must also insert the tap number or pixel number that you want to query. Refer to
Table 14 below for a list of available commands. To view a help screen listing the
following get commands, use the command
gh.
Table 14: Get Commands
Syntax Parameters
Description
get ccf
x1 x2
Returns the FPN pixel coefficients for the pixel range
indicated.
x1 = Pixel start number
x2= Pixel end number
get ccp
x1 x2
Returns the PRNU pixel coefficients for the pixel range
indicated.
x1 = Pixel start number
x2= Pixel end number
get clm
Returns the current camera configuration where:
0 = 8 bits, 1 tap
1 = 12 bits, 1 tap
2 = 8 bits, 2 taps
3 = 12 bits, 2 tap
To Next Page
Loading...
Need help?
General