84 PRELIMINARY Spyder 3 CL User's Manual
03-032-20008-03 DALSA
Syntax Parameters
Description
get dil
t a a
Displays LUT values:
t = Tap dependent: 0 for all. 1 and 2 for individual.
a1 = Start LUT address. In a range from 0 to 1023.
a2 = Stop LUT address, a1 < a2
get dpc
x1 x2
Returns pixel coefficients without formatting.
get eil
Returns LUTs status.
0: Off
1: On
get els
Returns whether the end-of-line statistics are turned off or
on.
0: Off
1: On
get epc
Returns whether pixel coefficients are enabled or
disabled.
The first parameter returns the FPN coefficients setting
where:
0 = FPN coefficients disabled
1 = FPN coefficients enabled
The second parameter returns the PRNU coefficients
setting where:
0 = PRNU coefficients disabled
1 = PRNU coefficients enabled
get gcm
Returns the camera’s model number
get gcs
Returns the camera’s serial number
get gcv
Returns the camera’s software version.
get ger
Returns the maximum exposure time for the current line
rate.
get gfc
x
Returns the FPN pixel coefficient for the pixel indicated.
get gl
x1 x2
Returns pixel values for the pixel range specified.
get gla
x1 x2
Returns the average of the pixel range indicated.
get gpc
x
Returns the PRNU pixel coefficient for the pixel indicated.
get gsf
i
Returns the frequency of the Camera Link control signal
indicated, either
1, 2, or 3.
get gsl
Returns the led status where:
get lpc
Returns the current coefficient set number.
get rfs
Returns whether factory settings have been saved. The
camera always returns
1 (factory settings have been
saved).
get roi
Returns the current region of interest.
To Next Page
Loading...
Need help?
General